A better fit starts here
Drive, profile & reach

Square drive and fastener size are different
The 1/4 in, 3/8 in or 1/2 in dimension describes the square connection to a handle or machine. The metric socket size describes the fastener it grips. Match both: never force a socket over a nut or use an unstable drive connection.
External hex versus internal hex
A six-point socket fits around an external-hex nut or bolt head. A male hex bit enters a recessed hex screw. Our long hex set contains male bit sockets, not sockets for external nuts. Deep sockets help with projecting studs; long bits reach recessed screws, but neither guarantees clearance around the tool.
Hand use is not impact use
Only the half-drive impact set in this range is described for impact use. It has no handle, machine, retaining pin or ring included. Check the equipment instructions for retention. Never use hand-only chrome sockets on an impact machine, extend a ratchet handle or treat a flex-head ratchet as a torque wrench.
Check the pieces, then work safely
Read the exact size list. Inspect sockets and fasteners for damage, seat fully, secure the work and protect your eyes. Wipe tools dry after use and inspect joints. For safety-critical tightening, use the correct torque equipment and the relevant fastening instructions.
Compare socket sets